The Open Lighting Project has moved!

We've launched our new site at www.openlighting.org. This wiki will remain and be updated with more technical information.

OLAGuruPlug

From wiki.openlighting.org
Jump to: navigation, search
Guru-plug-setup.png

This describes how to setup OLA on a GuruPlug. These devices make excellent low cost DMX512 nodes.

Features of this system:

  • Wifi access point with internet connectivity
  • RDM control either over DMX or ArtNet
  • Protocol conversion to/from: E1.31, DMX512, ArtNet, ShowNet, Pathport, SandNet, ESP Net

Costs involved:

  • GuruPlug, $99 +shipping
  • Ethernet Switch, from $30
  • USB DMX/RDM Interface, chose from Support Devices, usually around $100-$300
  • Wireless Cell Card, shop around. Make sure it works with Linux.


Prerequisites

This assumes you have a shell on the guru plug and that it can contact the internet to download the packages. Note that the default guru plug is insecure and comes with a lot of extras (samba, mysql, lighthttpd etc.) that aren't required. Removing these is outside the scope of this tutorial.

Installation

Add the following line to /etc/apt/sources.list:

 deb http://www.nomis52.net/data/ola-arm ./


Then apt-get install ola:

 $ apt-get update
 $ apt-get install olad

Setup

Add a user ola for the daemon to run as:

 $ adduser ola 

If you intend to use USB devices, you need to add this user to the plugdev & dialout groups. Modify the lines in /etc/group:

 dialout:x:20:ola
 plugdev:x:46:ola

Finally add any udev rules that you'll need. See OLA Device Specific Configuration

Running

Change to the ola user and the start the daemon:

 $ su ola
 $ olad -l 3

Now connect the the GuruPlug on port 9090 with your browser to configure it.

Questions

Ask on the mailing list http://groups.google.com/group/open-lighting