The Open Lighting Project has moved!
We've launched our new site at www.openlighting.org. This wiki will remain and be updated with more technical information.
We've launched our new site at www.openlighting.org. This wiki will remain and be updated with more technical information.
DMX512-A
From wiki.openlighting.org
Revision as of 05:40, 28 January 2007 by Beier (talk | contribs) (Dmx signals moved to DMX Signals: Corrected the case of the lettets)
A Universe contains 512 addresses and a single DMX line (cable) can only transmit one universe. I.e. a controller with two universes need two DMX lines (daisy chains including splitters). A uniververse is normally thought of as an address space (in the controller), the cables that transmits it and the equipment that receives it.
- The DMX signal is made up of a sequence which is sent over and over again (to increase robustness).
- The content is a "start byte" and 512 values, one value for every address.
- The address number is not sent over the lines, so the receiver must count the values from the start of the sequence to find the wanted value.
- A receiver must be set or programmed to an address it listens to. If a receiver listens to multiple addresses, the set one is the first.
- Multiple receiver can listen to the same address - the DMX system does not care.
- It is up to the controller/transmitter to decide how many addresses that should receive a value. Fever addresses means faster cycles.
Source: Wikipedia
